Ricoh InfoPrint 4100 TD3, Руководство по эксплуатации

Страница: 233 / 462

Table 13. Operator message codes (continued)
Code Description Reference
019F The premeasure gate is open (Auto
Load)
1. Press Auto Load Stop .
2. Clear the paper path.
3. Select OK .
4. Ensure that the forms are threaded
correctly.
5. Close the premeasure gate.
6. If this window reappears:
a. Shut down the system.
b. Power off the system.
c. Power on and retry the operation.
If this does not fix the problem, call for
service.
0237 Developer card failure
v
Ensure the developer communication
cable is plugged in correctly.
0782 Splice lever down
v
Ensure that the splice lever is in the
run position.
v See “About the splicing table” on page
15.
0783 Transfer station open
v
Ensure that the transfer station is
latched.
v
See “About the transfer station” on
page 16.
0784 Vacuum is OFF
v
Hold down the tension arm.
v Press the Vacuum push button to turn
on the forms vacuum.
v
See page “About the vacuum, stack
height, lift pin lever, and puller
controls” on page 19.
0785 Change toner collector bag See “Changing the toner collector bag”
on page 284.
0786 Add toner
0787 Check toner collector bag
v
Ensure that the toner collector is
properly positioned.
v
See “Checking the toner collector” on
page 282.
0788 Change developer mix See “Changing the developer mix” on
page 289.
0789 Developer drain open
v Ensure that the developer drain is
closed.
v
See “About the developer” on page
10.
078A End of Forms See “Loading forms” on page 69.
0791 Change fine filter See “Changing the fine filter” on page
300.
0792 Add fuser oil See “Adding fuser oil” on page 279.
Chapter 6. Taking care of problems
219