Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 159 / 180

159
ASCII Code
Use the ASCII Code shown below for the communication data.
The characters described with [ ] denote control codes.
Top
Bottom
00 10 20 30 40 50 60 70
0
[NUL] [DLE] (SP) 0 @ P ‘ p
1
[SOH] [DC1] ! 1 A Q a q
2
[STX] [DC2] ” 2 B R b r
3
[ETX] [DC3] # 3 C S c s
4
[EOT] [DC4] $ 4 D T d t
5
[ENQ] [NAK] % 5 E U e u
6
[ACK] [SYN] & 6 F V f v
7
[BEL] [ETB] ' 7 G W g w
8
[BS] [CAN] ( 8 H X h x
9
[HT] [EM] ) 9 I Y i y
A
[LF] [SUB] * : J Z j z
B
[VT] [ESC] + ; K [ k {
C
[FF] [FS] , < L ￥ l |
D
[CR] [GS] - = M ] m }
E
[SO] [RS] . > N ^ n ‾
F
[SI] [US] / ? O _ o [DEL]
Reference
• This ASCII Code differs from the ANSI Standard ASCII Code in the symbols denoted by the following codes.
• 5C (HEX)
• 60 (HEX)
• 7E (HEX)
• When using the external device set by 2-byte, NUL00 (HEX) can be used. Please add NUL00 (HEX) before STX or
after delimiter.
• To input the control codes in the barcode/2D code strings, set the code data as follows:
• The following control codes EOT, FS, GS, RS, or US you can set with BBS or SIN command by using ASCII code. In
this case, set the other characters by using ASCII code, too.
• To include the control codes other than EOT, FS, GS, RS, or US in the strings, set the all control codes with BRS or
SIN command by using these 2-byte alternate codes instead of ASCII code. In this case, set the other characters
including alphanumeric by using shift-JIS code.
Control code 00 (HEX) to 1F (HEX) 7F (HEX)
Alternate code F050 (HEX) to F06F (HEX) F071 (HEX)
• To input “FNC1” for CODE128, GS1 Data Matrix, GS1 DataBar Expanded, and 2D side of Composite code by
using BRS or SIN command, use the following alternate code. In this case, set the other characters including
alphanumeric by using shift-JIS code.
Control code FNC1
Alternate code F072 (HEX)
ME-LP400V-EX-6