Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 50 / 180

50
2-4-7 Count-up/Count-down value correction
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
T3
T4
T2
T5
T1
*1
*2
*2
SET IN
SET OK OUT *3
READY OUT
D8 to D15 IN
(Count-up/count-down
step times)
MARKING OUT
D0 to D7 IN
(Counter No.)
TRIG. IN *3
SELECT 0 to 2 IN
*1
*2
*2
Item Time Remarks
T1 0ms or more Keep the input until the SET OK is turned to ON.
T2 2 to 510ms One-shot output. Set the output time on the environment setting screen.
There is a margin for the setting value.
T3 ― • When laser pumping is completed
Period for creating marking data. It varies depending on the quantity of data to be
marked.
• When laser pumping is not completed
Period for creating marking data or period until the laser pumping is completed. The
longer one of the two above is employed.
T4 10ms or more Keep the ON status for 10ms or more.
T5 0.5ms or more After a lapse of 0.5ms or more from specifying SELECT 0 IN to SELECT 2 IN and D0 IN
to D15 IN, turn on SET IN.
*1 : Input SELECT 0 to 2 as the table below.
Number input target SELECT 0 (No. 20) SELECT 1 (No. 21) SELECT 2 (No. 22)
Count-up value correction OFF ON OFF
Count-down value correction ON ON OFF
*2 : Select a value from D0 to D7 for the counter number to correct the count-up/count-down value. Specify a value in D8
to D15 for the step times of count-up or count-down in the binary system. Refer to “Operation of input signal on I/O
connector” (P.34) for the detail.
*3 : To input “SET” signal during the marking operation as a next counter data, do not input “SET” until “MARKING” output
is turned ON.
ME-LP400V-EX-6