Introduction: Control Reference Guide
29
Intr
od
uc
tio
n
1.
SERIAL DIGITAL COMPONENT AUDIO and VIDEO
IN/OUT connectors
These connectors enable input and output of serial
digital component audio and video signals.
◆
NOTE:
• The input digital audio signals must be synchronized with
the video input signals. Otherwise, the audio signals will be
affected by noise.
• Use a 5C-FB or equivalent double-shielded cable to make
connections to the SERIAL DIGITAL COMPONENT
connector.
2.
IEEE 1394 digital input/output
This is an IEEE1394 digital interface. It inputs/outputs
IEEE1394 compressed digital signals that comply with
the IEC61883-1, IEC61883-2 and SMPTE396M
standards. Use 6-pin connectors. This connector does
not support bus power.
◆
NOTE:
• Use a double-shielded cable to make connections to the
IEEE1394 digital input/output connector.
• AVC-Intra 50 and AVC-Intra 100 recording and playback
do not support input/output via the IEEE 1394 connector.
• No input or output is available via the IEEE1394 connector
when something other than 59.94 or 50 is selected in setup
menu No. 25 (SYSTEM FREQ).
3.
ANALOG AUDIO OUT connectors
Output analog audio signals.
4.
ANALOG AUDIO IN connectors/impedance
switches/CH2 input switches
Analog audio input connectors
The input impedance of CH1-2 to CH3-4 can be
switched. The LINE, MIC and 48V switches make it
possible to use CH2 as a microphone input.
5.
Fan
Cools this unit. Install the unit making sure that the air
vents are not blocked. If the fan stops due to a
breakdown, “E-10” will appear on the counter display.
While the unit will operate even when the fan has
stopped, it should be shut down immediately.
6.
AC IN socket
Connect the supplied power cable to a power outlet.
7.
DC IN socket
Connect a 12 V DC power supply here. Use an external
12 V DC, 4.8 A (15 A peak or more) DC power supply.
When the voltage goes below approx. 10.6 V, the
power supply of this unit shuts down (When setup
menu No. 180 (BATTERY SEL) is not set to “TYPE-A” or
Rear Panel
SDI
DVCPRO/DV
IN
OUT
VIDEO
REF VIDEO IN TIME CODE AUDIO MON
AES/EBU
R
E
M
O
T
E
CH1·2
CH3·4
IN
IN
L
R
OUT
OUT
OUT
IN
IN
OUT
75
Ω
AUTO
1
2
3
4
5
6
7
8
5
9
13
12
10
14 11
LINE:
Line input for audio input signals from
audio device
MIC:
Audio input signal from microphone with
internal power supply (this unit does not
provide phantom microphone power).
+48 V:
Audio input signal from microphone with
external power supply (this unit provides
phantom microphone power).
