63
CIDRW System
User’s Manual
SECTION 3
Set
ting t
h
e Communica
tions
Cond
it
ions for the
CIDR
W
Controll
er
SECTION 3
Preparing for Communications
Return to Normal Operation Mode
When the Mode is Selected with the Mode Switch on the Bottom of the Unit
1.
Turn OFF the power to the CIDRW Controller.
2.
Set the mode switch on the bottom of the Unit
to the 0.
3.
When all of the devices to be used are connected, turn the power ON.
Start up in the Normal Operation mode.
Even if you restart with the mode switch left at the 3 position, or send a reset command "::EXIT," the Controller will start
in the Setting mode. To switch to Normal Operation mode, you must set the mode switch to 0.
When the Mode Is Selected by a Command Sent from the Host Device
1.
Either send the reset command "::EXIT" from the host
device or turn the power to the CIDRW Controller OFF
and then back ON.
Start up in the Normal Operation mode.
2
1
0
7
6
5
7
3
::EXIT
_
Содержание V640-HS61
