Omron V640-HS61, Руководство пользователя, Страница: 55 / 174

53
CIDRW System
User’s Manual
SECTION 3
Set
ting t
h
e Communica
tions
Cond
it
ions for the
CIDR
W
Controll
er
SECTION 3
Preparing for Communications
3.
When all of the devices to be used are connected, turn the power ON.
The system starts up in the Setting mode, and the indicators react as shown below.
 Sending a Switching Command from the Host Device
This method is convenient when the Unit has already been mounted and the switch on the bottom can-
not be repositioned to 3.
During operation in the Normal Operation mode, a command is sent from the host device to switch to
the Setting mode.
1.
Send a subsystem command (S18F13 ChangeState CPVAL1 = "PS") from the host device.
Refer to page 83
.
CPVAL1="PS" is an expansion designation unique to V700-L22 and does not conform to SEMI standards.
The system is automatically restarted and the mode switches to the Setting mode.
The operation indicators react as shown below.
Start Terminal Software
Use terminal software at the host device to set the CIDRW Controller.
The commands and communications conditions in the setting mode are unique to OMRON. They do not conform to the
SEMI standards. Use a Hyper Terminal or other terminal software that supports serial communications.
The communications conditions for communications between the host device and CIDRW Controller
are fixed. Make the following settings using the terminal software.
OPERATING ALARMS BUSY ERROR
OPERATING ALARMS BUSY ERROR
Item Setting
Baud rate 9600 bps
Data length 8 bits
Parity EVEN
Stop bits 1
Communications control None
Send code At the end of a line (when [ENTER] is input), the line feed characters ([LF]) are appended.
Display Local echo