Omron V640-HS61, Руководство пользователя, Страница: 46 / 174

44
SE
CTION 2
Con
n
ec
tions
a
nd Wiring
CIDRW System
User’s Manual
SECTION 2
Installation and Connections/Wiring
• Cable Information
• Wiring Method
1.
Attach crimp terminals to stripped portions of the cables.
2.
Insert the wires into the correct holes in the connector, bearing
the orientation of the connector in mind.
3.
Tighten the set screws of the connector firmly to secure the
cables.
The appropriate tightening torque is around 0.5 N·m.
A standard, tapered screwdriver will not enter all the way into the
screw holes. Use a small gauge flat-blade screwdriver whose shaft
and tip have the same thickness.
4.
Having fitted the connector to the cable, connect it
to an Amplifier Unit.
Orient the cable connector correctly in relation to the connector
on the Amplifier Unit, and fasten the cable connector by fully
tightening the retaining screws.
Disconnecting the connector
Fully loosen the two screws, then grip the projections on the connector and pull it straight out. If it is difficult to pull the
connector out, press down on the Amplifier Unit while pulling on the connector.
Recommended Models
Manufacturer Model
Cable RS-485 signal wire Tachii Electric Wire MVVS 2CX0.5SQ
Crimp terminals When one wire is connected
to each terminal. Phoenix Contact AI0.5-8WH
When two wires are con-
nected to each terminal. AI-TWIN2×0.5-8WH
Crimping tool CRIMPFOX UD6
Small flat-blade screw-
driver with no taper
Recommended Screwdriver
Manufacturer Model
OMRON XW4Z-00C
Side view
Face view
0.6 mm 3.5 mm
Set screws