![background image](http://html1.mh-extra.com/html/omron/sysmac-cj-series/sysmac-cj-series_operation-manual_743585037.webp)
Motion sequence and axes
Section 1-8
25
more information on the
BASE
command and the definition of the axis
sequence in an axis array, refer to the Trajexia Programming Manual,
chapter 3 (BASIC commands).
• If
SERVO=OFF
for one axis, the motion commands for that axis are
ignored.
• If the Following Error (
FE
) in one axis exceeds the parameter value
FELIMIT
, the next action occurs:
-
WDOG
is set to
OFF
and all axes stop.
-
SERVO
for the axis that causes the error goes to
OFF
.
- The current move is cancelled and removed from the buffer.
1-8-4
Type of axis
/i
ATYPE
Applicable to
Name
Description
0
All axes
Virtual axis
Internal axis with no physical out-
put. It is the only valid setting for
non-allocated axes. That is, those
that are not MECHATROLINK-II
Servo Drivers.
40
MECHATROLINK-II
Servo Drivers
MECHATROLINK-II
Position (default)
Position loop in the Servo Driver.
CJ1W-MCH72 sends position ref-
erence to the Servo Driver via
MECHATROLINK-II.
41
MECHATROLINK-II
Speed
Position loop in the Trajexia.
CJ1W-MCH72 sends speed refer-
ence to the Servo Driver via
MECHATROLINK-II.
42
MECHATROLINK-II
Torque
Position loop in the Trajexia.
CJ1W-MCH72 sends torque refer-
ence to the Servo Driver via
MECHATROLINK-II.
43
External driver con-
nected to encoder
input
Stepper output
Pulse and direction outputs. Posi-
tion loop is in the driver. CJ1W-
MCH72 sends pulses and
receives no feed back.
44
Servo axis
(Default)
Encoder
CJ1W-MCH72 receives position
from an incremental encoder.
45
Encoder
output
The same as stepper, but with the
phase differential outputs emulat-
ing an incremental encoder.
47
Absolute EnDat
Feedback is received from an
EnDat absolute encoder.
48
Absolute
SSI
Feedback is received from an SSI
absolute encoder.
49
MECHATROLINK-II
Inverters
Inverter as
axis
Inverters (with built-in encoder
interface) are controlled on the
MECHATROLINK-II bus as servo
axes.
Содержание SYSMAC CJ Series
