85
Service Manual – SW5500, FLOORTEC R 985
14 - Wheel System, Non Traction
Check and Adjusting Operation Drum Brake Cable (continues)
9 Lower the dust seal (J)
10 The parking brake is correctly regulated when:
◦
With the parking brake disengaged, the wheel (D) turns freely, without touching the braking
drums
◦
Keeping the brake lever (G) slightly turned upwards, the braking mass starts rubbing against the
wheel (D)
11 Perform the check described in the previous step, and if necessary adjust the brake tie rod (H) as
follows:
◦
Slacken off the nuts (I) and adjust them until the situation described in the previous step is met;
with the regulation complete, tighten down the nuts (I)
12 Perform in the reverse order steps 3 7 8 9 , Then repeat steps 3 7 8 9 For the other rear wheel
13 Perform steps 3 to 9 in the reverse order
14 Perform a practical check on the effectiveness of the parking brake on the two rear wheels
Figure 3:
G
H
D
I
I
H
J
