227
Service Manual – SW5500, FLOORTEC R 985
42 - Sweep System, Main Broom
Main Broom Wear Sensor and Adjustment (continues)
Adjustment
12 Use the knob (K) to lower the main broom until the end (L) of the lever (M) moves under the sensor (G),
in position (N)
13 In this position, insert the sensor (G), the nut (J) and the locknut (I), then adjust the sensor (G) to the
distance (P) of 4-5
mm; finally tighten the locknut (I) onto the nut (J).
14 Using the knob (K), raise the main broom, returning it to roughly its initial position
Installation
15 Assemble the components in the reverse order of removal, and note the following:
◦
After assembling the main broom, perform the height adjustment (see
in the relevant
paragraph)
Figure 25:
J
L
G
I
K
P
M
N
