Nidec Control Techniques Digitax-SF DA21223, Инструкция по эксплуатации

Страница: 291 / 386

8
Digitax SF
Instruction Man
ual
7. Tuning
2. Tuning Procedure
Stage 1
Quick Tuning
Setting the Inertia ratio and Optimizing Control Gain Set
The inertia ratio value is
entered by the user if known or can be estimated as part
of auto­tuning.
The control gain set will be automatically adjusted according to the
auto estimate of inertia ratio�
This method does not generate noise caused by any conflict between the inertia
ratio
and the gain set�
Page 9 Quick Tuning on
Digitax SF Connect
Page 14 Quick Tuning on Setup Panel
Stage 2
Final Tuning
Performed by Digitax SF
Connect ）
After Quick Tuning was performed, you might need further adjustments for some of
the parameters individually�
Final Tuning will improve responsiveness, settling time, and degree of freedom to
achieve optimal performance of equipment�
Page 12 Final Tuning: position control mode
1. Overview
Position Control Mode
Stage 1
Auto Tuning
Setting the Inertia ratio and Optimizing Control Gain
Set
The inertia ratio value is entered by the user if known or can be estimated
as part of auto­tuning.
You can select one of the control gain sets according to your equipment�
Auto estimated inertia ratio will be applied�
Page 17 Auto Tuning on Digitax SF Connect
Page 22 Auto Tuning on Setup Panel
Stage 2
Final Tuning
Performed by
Digitax SF
Connect
After Auto Tuning was performed, you might need further adjustments for some of
the parameters individually�
Final Tuning will improve responsiveness, settling time, and degree of freedom to
achieve optimal performance of equipment�
Page 20 Final Tuning: Velocity control mode
Velocity Control Mode
Optimizing the settling time and error
Suppressing vibration and noise
Optimizing the settling time and error
Suppressing vibration and noise