Motorola HT 1000, Руководство пользователя

Страница: 11 / 205

5
Check the Hardware
Connections After you connect the hardware, turn on the radio by turning the
volume control knob clockwise. You will hear one of the following
types of tones:
Note: You can install, start or explore the RSS using just the
diskettes and your computer if you do not have all the necessary
hardware. But you cannot read from or save codeplug data to an
actual radio and perform service functions if you do not have
the necessary hardware.
Note: If you are using a laptop computer and you plan to use the
RSS while the computer is in battery mode, you may need to set
the serial/parallel adapter to run on battery power. This can be
accomplished using the application diskette supplied by the
computer manufacturer. If this action is not performed, you are
likely to receive serial bus errors.
Note: If your RIB has a switch and LED, be sure to turn the switch on
before each programming session.
High-pitched, short
tone Hardware is connected correctly and the radio’s
internal firmware is operating properly.
Note: This tone may be disabled in the
codeplug and may not be heard.
Continuous low tone Critical failure or radio’s internal software
malfunction. Contact a service technician
immediately.
If the error is potentially fatal to the radio, the
radio’s operation will be inhibited.
When a non-fatal error is detected, the tone will
indicate that there is a problem, but the radio will
continue to operate. The error tone will be of the
same duration as the good tone, but will be 300
Hz instead of 900 Hz.
Caution
When programming or calibrating a radio, DO NOT
disconnect the radio from the RIB when the computer is
communicating with the radio. If you do so, the radio
may become inoperable. The only recommended time
to disconnect the radio is while you are at the MAIN
MENU or at any of the GET/SAVE/PROGRAM screens.
!