Sensor system*
Starting and driving 6-109
6
E00648200023
The detection areas can be changed as fol-
lows:
While the operation of the system is stopped
at the “SONAR” switch, press the “SONAR”
switch approximately 3 seconds or more, and
release it. The buzzer sounds twice to indicate
that the detection area has been changed.
While the operation of the system is stopped
at the “SONAR” switch, press the “SONAR”
switch approximately 3 seconds or more, and
release it. The buzzer sounds once to indicate
that the detection area has been changed.
E00648300297
In case there is a malfunction in the sensor
system, the display for the malfunctioning
sensor will blink and the warning buzzer will
sound for approximately 5 seconds.
Within approxi-
mately 60 cm
Continuous
CAUTION
The distances given are to be used for refer-
ence only, as errors may be caused by vari-
ous factors, such as temperature, humidity,
or the shape of the obstacles.
NOTE
When the sensors are detecting different
obstacles at the same time, the information
screen in the instrument cluster indicates the
directions of the obstacles each sensors are
detecting. However, closer obstacles are
given priority over other detected obstacles
and the warning buzzer sounds to inform you
of closer obstacles.
The volume of the warning buzzer can be
adjusted.
For details, consult an authorised
MITSUBISHI MOTORS dealer.
For vehicles equipped with the Multi Around
Monitor, you can change the setting to hide
the warning displayed on the side-view and
bird's eye-view screens.
For details, consult an authorised
MITSUBISHI MOTORS dealer.
Vehicle to obstacle
distance
Warning dis-
play/sound cycle
Changing the detection areas
Vehicles with a towbar
Vehicles without a towbar
NOTE
The mode of the detection area can be
switched only when the selector lever is in
the “R” (REVERSE) position.
The detection area will not change if you
keep the “SONAR” switch pressed for
10 seconds or more.
After pressing the “SONAR” switch, sensor
system operation differs according to the
detection area setting.
• Setting when towbar is not equipped
When the selector lever is moved to the “R”
(REVERSE) position, the sensor system
will operate even if corner sensor operation
was stopped by pressing the “SONAR”
switch.
• Setting when towbar is equipped
When sensor system operation was stopped
by pressing the “SONAR” switch, the sen-
sor system will not operate until the engine
has been stopped even if the selector lever
is moved to the “R” (REVERSE) position.
To resume sensor system operation, press
the “SONAR” switch or stop and restart the
engine, and then move the selector lever to
the “R” (REVERSE) position.
Warning display
NOTE
