How to change a tyre
For emergencies
8-15
8
3. Using the jack handle, turn the release
valve (D) clockwise until it stops.
4. Insert the jack handle in the bracket of the
jack and hook the notch (E) on the jack
handle end to the claw (F) of the bracket.
5. Move the jack handle up and down to
raise the ram until just before the jack
contacts the jacking point of the vehicle.
Ensure that the jack will properly contact
the vehicle jacking point.
Move the jack handle up and down to
raise the vehicle.
B- Rear jacking point
WARNING
Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
Do not use the jack on a tilted or soft sur-
face. Otherwise, the jack might slip and
cause personal injury. Always use the jack
on a flat, hard surface. Before setting the
jack, make sure there are no sand or peb-
bles under the jack base.
NOTE
When jacking up the rear of the vehicle, turn
the tip of the jack so that the grooved portion
(C) properly meets the designated point.
NOTE
This jack is a 2 stage expansion type.
WARNING
Stop jacking up the vehicle as soon as the
tyre is raised off the ground. It is danger-
ous to raise the vehicle any higher.
Do not get under your vehicle while using
the jack.
Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
