LNS GT 326-E, Инструкция по эксплуатации, Страница: 96 / 218

Chapter 8 OPERATION
8 - 19
GT 326-E
INTERFACE Refer to Interface
00 A1
– Clamping signal
Chuck signal logic setup
2
02 Pusher Motion Control
Pusher motion when chuck
closed in manual mode
1
03
Loading interrupt if A2 or A4
not activate
Pushing dependence when
chuck opens in bar change
process
1
04
A3 Priority load command from
lathe Defines if start loading signal
initiates bar change process
Subject to actual use
05
EOB signal required by the
lathe
Defines if EOB lit for initiating
bar change process as receiving
A3 signal
1
06 Loading cycle enabled
Bar change process initiation
with chuck open or chuck closed
1
07 Lathe headstock is
…
1. Fixed type
Subject to actual use
2. Sliding type
3. CAM type
09 Push signal from the lathe
Define if pushing depends on
Auto cycle or M-Code push
Subject to actual use
10 PLC input A2 is
…
1. Latched
1
2. Pulsed
11 A4 Signal is
…
1. Latched
1
2. Pulsed
12
2 pushing forces
(sliding headstock) Pushing force when chuck
opens
1
13 R2 while in production cycle
Start signal remains ON from
Top Cut to EOB
1
14 R2 during EOB
Defines the state of Start signal
after EOB
1
15 R2 ON at top cut position
Defines the state of Start signal
at TOP CUT
2
16 R2 to confirm
Defines if start signal (R2)
confirms TOP CUT position or
part feed out completion
1
17 R3 signal latches at EOB
Defines the type of EOB signal
output
1
18 R3 ON at EOB and OFF at
…
Defines when EOB signal turns
OFF
1
19 R3 ON at EOB and OFF at
…
Defines when EOB signal turns
OFF
2
20 R3 pulses for 2 sec. at EOB
Defines if EOB signal output
lasts 2 sec.
1
21 R5 ON at Aux. EOB position
Defines the output type of Aux.
EOB signal
1
22
Clamping device closed to start
AUTO Auto mode start depends on
Chuck signal
1
24 Auto signal connected to A2
Pushing depends on Auto signal
from the lathe
2