LNS GT 326-E, Инструкция по эксплуатации, Страница: 80 / 218

Chapter 8 OPERATION
8 - 3
GT 326-E
start the following sequencing:
 The long pusher moves forward to the extraction
position (behind the vise).
 The vise closes to check remnant disposal. Then after
the long pusher returns to its home position.
 The guiding channel opens.
2. If the pusher exceeds the po
sition “1ST FEED LOADING
FLAG POSITION
+150mm”, the channel will open when
pressing this key.
3. Loading a bar from the magazine into the channel
When the channel is open, pressing this key again the bar
measuring device will set in the ready position (up).
Close Guiding Channel
This key offers two functions :
1. When the pusher is at a position shorter than the First Feed
position and the bar feeder is in MANUAL mode , pressing this
key will automatically start the following sequencing:
 The loading flag moves forward to the First Feed
position.
 The short pusher returns to its home position.
 The guiding channel closes and the long pusher
advances for bar insertion. (If there
’s no bar, the bar
feeder will not cycle an insertion.)
1. If the channel is opened by pressing when the long
pusher is at a position exceeding
“1ST FEED LOADING
FLAG PO 150mm
” and the chuck of the lathe
open the guiding channel will close when pressing .