LNS GT 326-E, Инструкция по эксплуатации, Страница: 21 / 218

3 - 8
Chapter 3 SETTING INTO OPERATION
GT 326-E
3.3.3 Anchoring to the ground
Once the bar feed system is in place, and perfectly aligned, it should be anchored to the ground
to make it stable and secure. To accomplish this, 8 anchorage points are located in the base of
the front and rear legs. 8 anchoring bolts (B) must be furnished by the client (Minimum M 10 x
100 mm)(Minimum 1/2" x 4").
• Once the anchoring bolts are tightened, check the alignment again, and correct it if necessary
• Tighten the nuts of the leveling screws.
3.4 CONNECTIONS
Once the bar feeder is aligned and anchored to the floor the bar feeder must be connected to the
interface of the lathe and compressed air need to be connected.

For the electrical connection, please see Chapter 4, Electrics.

For the pneumatic connection, please see Chapter 5, Pneumatics.
 For the hydraulics, please see Chapter 6, Hydraulics.

For the mechanical connection, please see Chapter 7, General description.

For the parameter setting, please see Chapter 8, Operation.
B