LNS GT 326-E, Инструкция по эксплуатации, Страница: 19 / 218

3 - 6
Chapter 3 SETTING INTO OPERATION
GT 326-E
3.3 MOUNTING
3.3.1 Leveling
Attention: Prior to leveling and anchoring the bar feeder the lathe must be
leveled
1. Place the leveling pads (A) under each stands.
2. On each leg, loosen the lock nuts (B) of the leveling screws (C). Then, make sure that the
weight of the bar feed system is evenly distributed over the 12 support points.
3. Turn the screws (C) until they evenly touch the pads with an equal pressure on each pad.
4. Using a bubble level indicator level the bar feeder using the adjusting the leveling screws (C).
5. Loosen the lock nuts (D) and make sure that the central screws (E) of the front and rear feet
are supported. Loosen all locking screws (F).
6. Adjusting the central screws (E), set the height of the bar feed system. Normally, when the
reference point is known, this adjustment is approximately set at the factory.
7. Together with the vertical alignment, proceed with the lateral alignment, by shifting the
apparatus. Always maintain even pressure from the leveling screws to each leveling pad.
8. When the alignment is satisfactory, tighten all locking screws (F) and nuts (D). Check the
alignment and, if necessary, make the fine adjustment with the screws (C).
9. Anchor the bar feeder to the floor using anchoring bolts (G) and according to instructions in
the manual (3.3.3.)
10. Prior to securing the bar feeder to the floor it is recommended to check again the bar feeder
alignment. The bar feeder alignment is critical for good performance.
A
D
B
C
E
F
G