LNS GT 326-E, Инструкция по эксплуатации, Страница: 63 / 218

7 - 10
Ch 7 GENERAL DESCRIPTION
GT 326-E
6. Remove the guiding channels, store in a clean location and install newly selected channels.
7. Install the appropriate rotating sleeve and collet with collet adapter (if necessary) on the
pusher.
8. Install the loading flag and install the pusher corresponding to the guiding channel diameter.
Lay the pusher back into the guiding channels (pusher diameter is 1mm smaller than the
guiding channel diameter).
9. Install appropriate pusher hooks.
10. Release the Emergency Stop button and press to exit the emergency stop.
11. Press to close the guiding channels and press to move pusher back to its home
position.
12. Using the HMI enter the parameter
“Diameter& length” setup.
13. If configured for fixed headstock lathe install the corresponding spindle liner in the lathe. For
sliding headstock machines (Swiss type) replace either the spindle liner or the T-Tube liner.
14. Adjust front rest to the new bar diameter
15. The changeover is completed
Partial diameter changeover:
1. Follow the above steps 1 to 4.
2. Take out the pusher
3. Replace the collet and collet adapter if required
4. Put the pusher back into the guiding channels and lock the pusher in secure position
5. Release the Emergency Stop button and press to exit the emergency stop.
6. Press to close the guiding channels and press to move pusher back to its home
position.
7. Adjust front rest to the new bar diameter
8. Partial diameter changeover is complete
Rotating sleeve
Collet/adapter