LNS GT 326-E, Инструкция по эксплуатации, Страница: 106 / 218

Chapter 8 OPERATION
8 - 29
GT 326-E
19 R3 turns ON at EOB and turns OFF at
(Refer to INTERFACE17, 18, 20, 31, 32, 33 for related setup)
Defines when R3 signal turns OFF.
1 R3 signal turns OFF when A3 signal is activated
and the pusher retracts back to home position.
2 R3 signal turns OFF when the new bar reaches
Top Cut position
＊
Refer to the timing chart <4> on 8.6.2.1
20 R3 pulses for 2 sec. at End of Bar
(Refer to INTERFACE17, 18, 19, 31, 32, 33 for related setup)
Defines if R3 signal pulses for 2 seconds or not.
1 R3 signal is not a pulse signal. Refer to
INTERFACE18, 19 or 33 for related setup on to
turning OFF.
2 R3 signal is a 2 seconds pulses signal.
＊
Refer to the timing chart <4> on 8.6.2.1
21 R5 ON at Aux. EOB position (Refer to INTERFACE43 for related setup)
When the pusher arrives at
“AUXILIARY END OF BAR”
position, R5 signal turns ON. This parameter defines the
output type of R5 signal.
1
R5 signal turns ON when pusher passes the Aux.
EOB position.
2 R5 remains ON when the pusher exceeds the Aux.
EOB position until the bar feeder loads a new bar
stock.
This parameter is only applied if INTERFACE43 set 1.
22 Clamping device closed to start AUTO
Defines if the chuck of the lathe must be closed at Auto
Start of the bar feeder.
1 Safety setup. The chuck of the lathe must be closed
before switching to automatic mode.
2 The chuck condition of the lathe does not matter to
switch the bar feeder to automatic mode.