LNS GT 326-E, Инструкция по эксплуатации, Страница: 6 / 218

Chapter 1 BASIC NOTIONS 1 - 3
GT 326-E
1.3 SAFETY INSTRUCTIONS
 Do not handle the equipment without having knowledge of the safety instructions and the
instructions for use. Safety instructions for the bar feeder, as well as the CNC lathe, must
be strictly observed. We disclaim all responsibility for possible accidents or property
damage caused by not following our safety instructions.

Non-qualified personnel, children, and people under the influence of alcohol or medication
should not handle the equipment.
 Loose garments, long hair and jewelry can be dangerous.
 Do not remove any covers while the bar feeder or the machine is under electrical power.

Do not conduct any maintenance operations during the automatic cycle.
 Do not grasp moving or rotating objects, or nearby elements.
 If certain safety shields or safety covers are removed to conduct maintenance, they must
be reinstalled as soon as the maintenance work is completed.

No servicing should be carried out on the interface or inside the electrical cabinet while the
bar feeder or the lathe is under electrical power.
 It is strictly prohibited to jump wire of remove circuit breakers, main switches, and especially
safety switches.
 To avoid any harm to people, or damage to components, use only the indicated points for
lifting and moving the bar feeder system. No one should be near the handing load, or within
the operating range of the overhead hoist/crane, forklift, or any other means used for lifting
and transportation. Do not knock the bar feeder while moving it as this could damage it.
 Do not move the bar feeder while it is electrically powered on.

Please use the bar feeder in a clean environment.

Please do not use the bar feeder with extreme heat or humidity environment.
 The working area surrounded the bar feeders should always be clear of objects and well lit.
The presence of oil on the ground could cause falls; it is important to maintain the floor
clean on a regular basis.
 Do not place the machine in a damp area and make sure that water or oil does not come
into contact with the electrical equipment.

Do not open the clamping device (collet or chuck) of the lathe manually when the bar
feeder is in AUTOMATIC mode (interface).
 Each time the diameter is changed, also adapt spindle reduction tube. The use of spindle
reduction tubes is highly recommended for machining bars with diameters smaller than the
maximum capacity of the spindle.
 There is no battery inside the PLC. Do not attempt to recharge it.
 For the use and maintenance of the bar feeder, use only parts provides by or
recommended by us.

If it is necessary to move the bar feeder after it has been originally installed, do not reinstall
it before first contacting our representative.

We disclaim all responsibility for possible accidents or property damage when safety device
is removed.