Replace missing cartridge [31.xy]
Install the missing cartridge to clear the message. For more information, see
“Replacing the toner cartridge”
.
Replace paper pick rollers in [paper source], use parts and instructions in
tray 1 or tray 2 compartment [80]
Try one or more of the following:
•
Replace the pick rollers, and then touch
Rollers replaced
on the control panel to clear the message
and continue printing.
•
Touch
Replace later ( jams may persist)
to ignore the message and continue printing.
Replace photoconductor, 0 pages remain [84.xy]
Replace the photoconductor unit to clear the message and continue printing. For more information, see the
instruction sheet that came with the supply or see
“Replacing a photoconductor unit” on page 137
.
Note:
If you do not have a replacement photoconductor unit, then see
“Ordering supplies” on page 135
or go to
Replace unsupported cartridge [32.xy]
Remove the toner cartridge, and then install a supported one to clear the message and continue printing.
For more information, see the instruction sheet that came with the supply or see the “Replacing supplies”
section of the
User’s Guide
.
Note:
If you do not have a replacement cartridge, then see the “Ordering supplies” section of the
User’s
Guide
or visit
Replace unsupported photoconductor [32.xy]
Remove the photoconductor unit, and then install a supported one to clear the message and continue
printing. For more information, see the instruction sheet that came with the supply or see
photoconductor unit” on page 137
Note:
If you do not have a replacement photoconductor unit, then see
“Ordering supplies” on page 135
or go to
Replace waste toner bottle [82.xy]
Replace the waste toner bottle to clear the message.
Restore held jobs?
Try one or more of the following:
•
From the printer control panel, touch
Restore
to restore all held jobs stored in the printer hard disk.
•
From the printer control panel, touch
Do not restore
if you do not want to restore any of the print jobs.
Troubleshooting
197
Содержание MS910 Series
