Lenovo HX1310, Инструкция по установке и обслуживанию

Страница: 130 / 1002

The following illustration shows the location of the DIMM connectors on the system board.
Figure 41. DIMM connectors location
DIMM installation sequence
When you install additional DIMMs, install them in the order shown in the following table to optimize system
performance.
In general, all four channels on the memory interface for each microprocessor can be populated in any order
and have no matching requirements.
Table 23. Normal mode DIMM installation sequence
Number of installed
microprocessors
DIMM connector population sequence
One microprocessor installed 1, 4, 9, 12, 2, 5, 8, 11, 3, 6, 7, 10
Two microprocessors installed 1, 13, 4, 16, 9, 21, 12, 24, 2, 14, 5, 17, 8, 20, 11, 23, 3, 15, 6, 18, 7, 19, 10, 22
Memory mirrored channel
Memory mirrored channel mode replicates and stores data on two pairs of DIMMs within two channels
simultaneously.
If a failure occurs, the memory controller switches from the primary pair of memory DIMMs to the backup
pair of DIMMs. To enable memory mirrored channel through the Setup Utility, select
System Settings ➙
Memory . For more information, see “Using the Setup Utility” on page 31. When you use the memory
mirrored channel feature, consider the following information:
• When you use memory mirrored channel, you must install a pair of DIMMs at a time. The two DIMMs in
each pair must be identical in size, type, and rank (single, dual, or quad), and organization, but not in
speed. The channels run at the speed of the slowest DIMM in any of the channels.
116
HX1310, HX2310-E, HX3310, HX3310-F Installation and Service Guide