SERVICE MANUAL
2-8
9G9002 – 2011-08-15
[5]
Check for a 2.00 mm (0.08 in.) half-tone density at the leading edge of the film with no transparent area
appearing.
To Adjust:
[1]
Select
Configuration > Hardware > Optics
.
[2]
Observe the number displayed in the Page Start Delay window.
Note
There are two Page Start Delay adjustments depending on the width of the film. Make sure you are adjusting for the
correct film width.
• When viewing the film on a light box, make sure you are looking at the leading edge.
• If the half-tone density, as viewed on a light box, is less than 2 mm, the number must be decreased.
• If the half-tone density, as viewed on a light box, is greater than 2 mm, the number must be increased.
[3]
To decrease or increase the half-tone density border on the test print, do one of the following:
[4]
Click
Save
.
[5]
Make another test print and check the Page Start Delay area again.
[6]
Repeat Steps
3
–
5
until the half-tone density border is within specification.
To increase the border:
To decrease the border:
Click
Modify
and
decrease
the number in
the Page Start Delay window.
Click
Modify
and
increase
the number in
the Index Delay window.
Increasing or decreasing the Page Start Delay value by
13
is equal to a 1.00 mm
(0.04 in.) change.
Printing above half-tone border
2.00 mm (0.08 in.) half-tone density border
Correct
Incorrect
