Diagnostics
9G9002 – 2011-08-15
4-67
Condition Code: 27-646 – Start of Page Error
Condition Code: 27-650 – Exposure Timeout Error
Web Portal Message
Log Message
DICOM Printer
StatusInfo
Severity
Optics: Internal
Hardware Failure
Optics hardware failed
to report start of page
although Start of Page
sensor (S6) detected
film
ELEC DOWN
0-Fatal
Description
This error occurs if the optics hardware does not report the start-of-page
condition even though the start-of-page (SOP) sensor (S6) did indicate the
leading edge of the film has been detected. The image is likely blank, but the
film is not jammed and should exit the imager successfully.
The error clears only when power is cycled.
System Impact
The imager can only print jobs that were in process when the error occurred.
The spooler can still accept jobs, but the jobs will not print until the error is
resolved. All jobs that were in process when the error occurred will reprint
completely when the error is resolved. [SI-1]
User Action
1. Shut down the laser imager, and then restart the imager.
2. If the error persists, call for service.
Show at DS
True
DICOM Printer
Status
FAILURE
Unique Symb. ID
ERR_START_OF_PAGE
Web Portal Message
Log Message
DICOM Printer
StatusInfo
Severity
Optics: Internal
Hardware Failure
Image Exposure time
out failure – multiple
successive timeouts
ELEC DOWN
0-Fatal
Description
This error occurs when the image exposure does not complete in the required
time for 3 successive films. The error is cleared when the imager power is
cycled.
System Impact
The imager can only print jobs that were in process when the error occurred.
The spooler can still accept jobs, but the jobs will not print until the error is
resolved. All jobs that were in process when the error occurred will reprint
completely when the error is resolved. [SI-1]
User Action
1. Shut down the laser imager, and then restart the imager.
2. If the error persists, call for service.
Show at DS
True
DICOM Printer
Status
FAILURE
Unique Symb. ID
ERR_EXPOSE_TMO_FAIL
