SERVICE MANUAL
4-66
9G9002 – 2011-08-15
Condition Code: 27-609 – Optics Maximum Laser Power Approaching Limit
Condition Code: 27-611 – Optics Laser Gain Adjustment Failed
Web Portal Message
Log Message
DICOM Printer
StatusInfo
Severity
None
Optics calibration
detected Optics
Maximum Power
approaching limit
NORMAL
3-Notify
Description
This notification occurs when the maximum laser power measured by the optics
calibration and diagnostics is approaching the predefined valid limit.
System Impact
None. The system will function normally. [SI-0]
User Action
None
Show at DS
False
DICOM Printer
Status
NORMAL
Unique Symb. ID
ERR_OPTICS_MAX_LASER_POWER_NEAR_LIMIT
Web Portal Message
Log Message
DICOM Printer
StatusInfo
Severity
Optics: Internal
Hardware Failure
Optics calibration laser
power gain adjustment
failed
ELEC DOWN
0-Fatal
Description
The laser power gain is measured using a voltage on the laser driver. This error
occurs when the laser driver voltage cannot be adjusted to within limits by the
optics calibration after 20 successive attempts.
System Impact
The imager can only print jobs that were in process when the error occurred.
The spooler can still accept jobs, but the jobs will not print until the error is
resolved. All jobs that were in process when the error occurred will reprint
completely when the error is resolved. [SI-1]
User Action
1. Shut down the laser imager, and then restart the imager.
2. If the error persists, call for service.
Show at DS
True
DICOM Printer
Status
FAILURE
Unique Symb. ID
ERR_OPTICS_LASER_GAIN_FATAL_ERROR
Logged for RMS
[TriggerValues=x][TriggerRange=y,z][TriggerNotes=Laser Voltage: value,
limits]
