Installation Instructions
9G9002 – 2011-08-15
1-9
Configuring the Laser Imager
This section instructs how to configure the laser imager using the same methods available to the customer in the
Installation Manual, 9G7567. For additional and more comprehensive configuration procedures, see
Section 6:
Additional Service Procedures
.
Important
You must restart the laser imager from the service tool to permanently save configuration information.
Setting Up Your Computer to Communicate with the Laser Imager
Do this procedure at your computer.
[1]
Select
Start > Settings > Network Connections
.
Note
Depending on your operating system, this might be
Start > Settings > Network and Dial-up Connections
.
[2]
Right-click
Local Area Connection
.
[3]
Select
Properties
.
[4]
Select
Internet Protocol (TCP/IP)
.
[5]
Click
Properties
.
Important
Remember or write down your current settings, as you will reset your computer to these settings near the end of the
installation.
[6]
Select the
Obtain an IP address automatically
option.
[7]
Click
OK
.
[8]
Click
OK
.
