Additional Service Procedures
9G9002 – 2011-08-15
6-17
Upgrading the Imager Flash Drive with a New Version of System Software – Ghosting
Important
Save the backup file to your laptop computer.
[1]
Make a backup of the configuration file for the imager (see
“Making a Configuration Backup”
).
[2]
Close the film cartridge.
[3]
De-energize the imager.
[4]
Remove the back cover (see Adjustments and Replacements,
“Back cover”
).
[5]
Install the portable flash drive that contains the ghost software into one of the USB ports on the DRE board.
Note
The USB ports are located behind the lower 2 network connections.
[6]
Install the back cover, and then attach the power cord.
[7]
Energize the imager to begin ghosting.
The imager beeps 3 times when ghosting has completed.
[8]
After ghosting has completed, de-energize the imager.
[9]
Remove the back cover, and then remove the portable flash drive.
[10]
Install the back cover, and then attach the power cord.
[11]
Energize the imager.
[12]
Do the microcontrollers need to be updated?
[13]
Perform
“Restoring the Configuration”
.
Yes
No
a. Perform
“Upgrading the Firmware in
the Microcontrollers”
b. Continue with Step
13
.
Continue with Step
13
.
USB
Ports (4)
