SERVICE MANUAL
2-6
9G9002 – 2011-08-15
To Adjust:
[1]
Select
Configuration > Hardware > Optics
.
[2]
Observe the number displayed in the Index Delay window.
Note
There are two Index Delay adjustments depending on the width of the film. Make sure you are adjusting for the correct
film width.
• When viewing the film on a light box, the notch on the film must be in the upper right.
• If the left border, as viewed on a light box, is too narrow, the number must be decreased.
• If the left border, as viewed on a light box, is too wide, the number must be increased.
[3]
To decrease or increase the left border on the test print, do one of the following:
[4]
Click
Save
.
[5]
Make another test print and check the Index Delay area again.
[6]
Repeat Steps
3
–
5
until the left border matches the right border.
To decrease the left border:
To increase the left border:
Click
Modify
and
increase
the number in
the Index Delay window.
Click
Modify
and
decrease
the number in
the Index Delay window.
Increasing or decreasing the Index Delay value by
13
is equal to a 1.00 mm (0.04 in.)
change.
