■
The backup Routing Engine may generate routing protocol process and kernel
cores if the BGP damping is configured along with nonstop active routing (NSR).
[PR/452217]
■
On JUNOS OSPF, all locally generated Type 5 LSAs are purged and regenerated
while deleting an NSSA area from the area border router (ABR). [PR/457579]
■
When aggregate interfaces are used for VPN applications, load balancing may
not occur with a Layer 2 circuit configuration. [PR/471935]
■
During transient periods where both a secondary and primary LSP exist in a
routing table, and the number of LSP NHs is greater than 16 in a multigateway
scenario, IS-IS may remove the preferred LSP NH. For example, IS-IS could
remove an HIPRI LSP. [PR/485748]
■
The Juniper Networks rendezvous point (RP) does not process PIM Register
messages from a first-hop router in an IPv6 embedded RP group when the
Register message does not have the null-bit set. [PR/486902]
■
When l3vpn-composite-next-hop is configured, it should only be used by L3VPN
routes. However, non-L3VPN routes are also able to use it. [PR/496028]
■
The BGP BMP message for IPv6 withdraw encoding does not follow the BMP-draft.
[PR/512780]
■
When an interface comes up after a down event, and LDP-IGP sync is configured
for that interface, OSPF does not include the interface in its LFA calculations
while the interface is in LDP Sync hold-down state. [PR/515482]
■
The output of the
show igmp snooping interface
command does not display
"-snooping," erroneously stating that IGMP itself is not running instead of
IGMP-snooping not running. [PR/516355]
■
The configured robust count value is not applied on the non-querier router when
it receives a robust count value of 0. It uses the default value (2) instead of the
configured value. [PR/520252]
■
The new NSR master may not send the OSPF hello messages immediately after
a switchover. [PR/522036]
Services Applications
■
The
show services accounting flow-detail extensive
command sometimes displays
incorrect information about input and output interfaces. [PR/40446]
■
When a routing platform is configured for graceful Routing Engine switchover
(GRES) and Adaptive Services (AS) PIC redundancy, and a switchover to the
backup Routing Engine occurs, the redundant services interface (rsp-) always
activates the primary services interface (sp-), even if the secondary interface was
active before the switchover. [PR/59070]
■
When the Border Signaling Gateway (BSG) configuration contains a policy that
has a term with regular expressions, configuration changes might not take effect
immediately after the commit process is complete. In most cases, the new policy
takes effect immediately. However, complex policies may take longer to take
effect depending on how many regular expressions they contain.
For example, if you have a term with four regular expressions, configuration
changes do not take effect until 50 seconds after you receive the message that
62
■
Issues in JUNOS Release 10.1 for M Series, MX Series, and T Series Routers
JUNOS 10.1 Software Release Notes
