Virtual LANs (VLANs)
■
On SRX650 devices, when VLAN tagging is configured and traffic is sent, the
output of
show interfaces ge-0/0/1 media detail
VLAN tagged frame count is not
shown. [PR/397849]
■
On SRX240, SRX650, J4350, and J6350 devices, tagged frames on an access
port with the same VLAN tag are not getting dropped. [PR/414856]
■
On SRX100, SRX210, and SRX240 devices, the packets are not being sent out
of the physical interface when the VLAN ID associated with the VLAN interface
is changed. As a workaround, you need to clear the ARP. [PR/438151]
■
On SRX100 Low Memory, SRX100 High Memory, SRX210 Low Memory, SRX210
High Memory, SRX240 High Memory, and SRX650 devices, the Link Layer
Discovery Protocol (LLDP) organization-specific Type Length Value (TLV), medium
attachment unit (MAU) information always propagates as "Unknown".
[PR/480361]
■
On SRX100 High Memory devices and SRX210 Low Memory devices, dot1x
unauthenticated ports accept Link Layer Discovery Protocol (LLDP) protocol data
units (PDUs) from neighbors. [PR/485845]
■
For SRX210 High Memory devices, during configuration of access and trunk
ports, the individual VLANs from the vlan-range are not listed. [PR/489872]
VPNs
■
On SRX5600 devices, the shared IKE limit for IKE users is not currently enforced.
More users than are specified in the shared IKE limit are able to establish
IKE/IPsec tunnels. [PR/288551]
■
On SRX210 and SRX240 devices, concurrent login to the device from a different
management systems (for example, laptop or computers) are not supported.
The first user session will get disconnected when a second user session is started
from a different management system. Also, the status in the first user system is
displayed incorrectly as “Connected”. [PR/434447]
■
On SRX Series and J Series devices, the site-to-site policy-based VPNs in a three
or more zone scenario will not work if the policies match the address “any”,
instead of specific addresses, and all cross-zone traffic policies are pointing to
the single site-to-site VPN tunnel. As a workaround, configure address books in
different zones to match the source and destination, and use the address book
name in the policy to match the source and destination. [PR/441967]
WLAN
■
On SRX Series devices, when WLAN configuration is committed, it takes a while
before the configuration is reflected on the access point, depending on the
number of virtual access points and the number of access points connected.
[PR/450230]
■
On SRX210, SRX240 and SRX650 devices, J-Web online Help displays the list
of all the countries and is not based on the regulatory domain within which the
access point is deployed. [PR/469941]
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
■
157
Issues in JUNOS Release 10.1 for SRX Series Services Gateways and J Series Services Routers
