IBM PS700, Руководство по диагностике и обслуживанию

Страница: 217 / 294

v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
See Chapter 3, “Parts listing, Type 8406,” on page 229 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Isolation
Procedure Code
Symptom Action
FSPSP10 The part indicated in
the CRU callout that
follows this
procedure is invalid
or missing for this
system's
configuration.
1. If there is only one CRU called out after this FSPSP10 call:
a. Verify that the CRU is installed, connected, and seated properly.
b. If the CRU is seated properly and the problem persists, replace
the CRU.
c. If the CRU is missing, add the CRU.
2. If multiple CRUs are called out, they have identical serial numbers.
Remove all but one of the CRUs.
FSPSP11
The service processor
has detected an error
on the RIO/HSL port
in the system unit.
1. Verify that the operating system is running. If it is running, perform
an in-band firmware update, as described in “Updating the
firmware” on page 263.
2. If the problem persists, replace the system board and chassis
assembly, as described in “Replacing the FRU system-board and
chassis assembly” on page 260.
FSPSP12 The DIMM CRU that
was called out failed
to correct the
memory error. Replace the system board and chassis assembly, as described in
“Replacing the FRU system-board and chassis assembly” on page 260.
FSPSP14 The service processor
cannot establish
communication with
the server firmware.
The server firmware
will continue to run
the system and
partitions while it
attempts to recover
the communications.
Server firmware
recovery actions will
continue for
approximately 30 to
40 minutes.
1. View the event log in the management module to locate the system
reference code (SRC) and the time that the event was logged. See
“Error logs” on page 183.
If progress codes are being displayed, the server firmware was able
to reset the service processor and solve the problem.
2. Record the time the log was created or when you first noticed this
SRC.
3. If progress codes are not being displayed, examine the management
module event log to see if an A7006995 SRC has been displayed.
If an A7006995 SRC has been displayed, the blade server is powering
off partitions and attempting a server dump. Follow the action in the
A7006995 SRC description if the partitions do not terminate as
requested.
4. If an A7006995 SRC has not been displayed, has the A1xx SRC
remained for more than 40 minutes?
If so, the server firmware could not begin terminating the partitions.
Contact your next level of support to assist in attempting to
terminate any remaining partitions and forcing a server dump.
Collect the dump for support and power off and power on the blade
server.
5. If an A1xx SRC has not remained more than 40 minutes, call IBM
Support.
FSPSP16 Save any error log
and dump data and
contact your next
level of support for
assistance. Contact IBM Support.
Chapter 2. Diagnostics
205