H3 HUMMER 2007, Руководство пользователя

Страница: 251 / 318

It is not a good idea to "top up"
your brake fluid. Adding brake
fluid will not correct a leak. If you
add fluid when the linings are
worn, then there will be too much
fluid when you get new brake
linings. You should add (or
remove) brake fluid, as necessary,
only when work is done on the
brake hydraulic system.
6
CAUTION
If there is too much brake fluid, it
can spill on the engine. The fluid
will burn if the engine is hot
enough. You or others could be
burnt, and your vehicle could be
damaged. Add brake fluid only
when work is done on the brake
hydraulic system.
Check the master cylinder fluid
level in the "see-through" reservoir
at the intervals shown in the Main­
tenance Schedule.
The level should be between the
MIN
and
MAX
marks.
Low fluid level can indicate a leak in
the brake system. Have the vehicle
serviced as soon as possible.
If work has just been done on the
brake hydraulic system and the
fluid level is low, bring it up to the
proper level using DOT-4 fluid
from a sealed container.
See "Recommended Fluids and
Lubricants" later in this section.
Section 4
To prevent contamination of the
brake fluid, make sure the brake
reservoir and cap are thoroughly
clean before removing the cap.
6
CAUTION
With the wrong kind of fluid in
your brake system, your brakes
may not work well, or they may
not even work at all. This could
cause a collision. Always use the
proper brake fluid.
NOTICE
Using the wrong kind of fluid
could severely damage system
components. Always use the
proper brake fluid.
Don't spill brake fluid on the
vehicle's exterior surfaces. It can
damage your paint. If you do,
wash it off immediately.
251 ...