GW Instek GSM-20H10, Руководство пользователя

Страница: 356 / 374

COMMAND SYNTAX
354
· Bit B7, Power ON (PON) — Set bit indicates that the
SourceMeter has been turned off and turned back on since
the last time this register has been read.
˙
Operation Event Register
The used bits of the Operation Event Register are described as
follows:
z
Bit B0, Calibrating (Cal) — Set bit indicates that the
SourceMeter is calibrating.
z
Bits B1 and B2 — Not used.
z
Bit B3, Sweeping (Swp) — Set bit indicates the instrument
is performing a sweep operation.
z
Bit B4 — Not used.
z
Bit B5, Waiting for Trigger Event (Trig) — Set bit indicates
that the SourceMeter is in the trigger layer waiting for a
TLINK trigger event to occur.
z
Bit B6, Waiting for Arm Event (Arm) — Set bit indicates
that the SourceMeter is in the arm layer waiting for an
arm event to occur.
z
Bits B7 through B9 — Not used.
z
Bit B10, Idle State (Idle) — Set bit indicates the SourceMeter
is in the idle state.
z
Bits B11 through B15 — Not used.
˙
Measurement Event Register
The used bits of the Measurement Event Register are described
as follows:
z
Bit B0, Limit 1 Fail (L1) — Set bit indicates that the Limit 1
test has failed.
z
Bit B1, Low Limit 2 Fail (LL2) — Set bit indicates that the
Low Limit 2 test has failed.
z
Bit B2, High Limit 2 Fail (HL2) — Set bit indicates that the
High Limit 2 test has failed.