Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 58 / 133

58
In
tr
oduc
tion
Pr
oduc
t Description
Instruc
tions f
or use
Technica
l Inf
ormation
Insta
llation
Main
tenance
Spar
e P
ar
ts
Appendix
Con
ten
ts
Declar
ation
Oper
ation & Main
tenance Manual SpeedStile B
P DS
When the parameter Main-menu/Setup/Serial 485/Enable is set to “DISABLED”, then the access
mode will be set by the Remote Interface .The remote interface is a set of Electrical digital Inputs
whose combination determines the access mode settings (see the annex “Parameter Table”).
Operation modes are set by means of specific inputs on the GC01 board.
All these inputs are drivable with dry contact or NPN open collector, they are low active.
n
ote
-f
or more detaIlS
,
See
f
Igure
– r
emote
c
ontrol
I
nterface
c
onnectIon
(
See SectIon
8 “a
ppendIx
a - w
IrIng
S
chematIcS
”).
Special Functions
The SpeedStile BP DS entrance offers the possibility of using special functions, which allow the
installation and maintenance personnel to carry out operating tests, configure parameters and
observe status and testing messages of the system.
The available functions are listed below:
1. MB01 Maintenance Operations.
2. Learning Cycle.
3. MB01 EEPROM erasing.
4. Alarm and fault message display.
5. Firmware version code display.
6. Tests of gate panel movement mechanisms.
7. Photocells tests.
8. Battery test.
9. Buzzer test.
10. Traffic lights and pictograms test.
11. Output relays test.
12. Modification of programmable parameters.
13. Base configuration of programmable parameters.