Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 62 / 133

62
In
tr
oduc
tion
Pr
oduc
t Description
Instruc
tions f
or use
Technica
l Inf
ormation
Insta
llation
Main
tenance
Spar
e P
ar
ts
Appendix
Con
ten
ts
Declar
ation
Oper
ation & Main
tenance Manual SpeedStile B
P DS
When in MB01 maintenance the board is disconnected from the Gate Controller and will no
longer answer or execute any commands coming from the Controller, the control board goes into
stand-by and displays:
M S
M A I N T E N A N C E
S L S T A N B Y
SW1
SW2 SW3
RESET
M S: Master
S L: Slave
The board is then standing alone. In this state and only in this state the user can set the
trim and test the board. The following function is not differently indicated but is intended to be
executed in maintenance mode.
Checking the Mechanism Movement
The MB01 logic offers a simple human interface that allows you to carry out several different
operations.
That interface is composed of 4 push buttons (S1,... S4) and a 7 segment display.
In maintenance mode S1 - S4 work in the following manner:
S1 Reset
S2 Gives the opening command to the mechanism controlled by the MB01 board
(ENTER).
S3 Launches the learning cycle: the MB01 executes few opening/closing cycles in
order to record the motor current slopes due to the trimmers setting (UP).
S4 Gives the closing command (DOWN).
S2 + S4 When pushed at the same time, the MB01 starts the repeated open/close
commands sequence in order to test the complete movement of the mechanism.
n
ote
-d
urIng thIS repeated Sequence
,
the
mB01
controlS the preSence of oBStacle durIng the
movement
.
t
hIS command IS overwrItten wIth any SwItcheS and conSequently the movement StopS
.
n
ote
-t
heSe commandS are Independent
.
In maintenance mode, when one of the trimmers is changed, for a few seconds the display
shows the current position that is selected (0, 1, ...5).
For this check, set the trimmer TR1 = 1 and push the button S1: