Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 21 / 133

21
Appendix
Declar
ation
Spar
e P
ar
ts
Main
tenance
Insta
llation
Technica
l Inf
ormation
Instruc
tions f
or use
pr
oduc
t Description
In
tr
oduc
tion
Con
ten
ts
Oper
ation & Main
tenance Manual SpeedStile B
P DS
The alarm signal continues until the cause which generated it is removed.
The activation of the alarm signal output relay could be delayed by means of a programmable
parameter. The flashing frequency of the traffic lights and pictograms can be regulated by means of
a programmable parameter.
These parameters are described into “Fraud Group” in the annex “Parameter Table”.
When the system is in an alarm state, the unit can still accept validation signals from the access
control system, but the user will not be able to begin the transit until the alarm has cleared and the
unit has returned to its secure default configuration.
By means of a programmable parameter (see “Reader Group” in the annex “Parameter Table”),
the logic could be set to ignore any new reader authorization during the alarm. In that case the
authorization is not registered by the system and the user will need to restart the signal validation
process after the alarm has cleared and the unit is back to its secure default configuration.
The tailgating detection system selectivity of the SpeedStile BP DS can be tuned (the ability to
intercept a person who follows a person with authorisation for transit) with the friendly usability of
the gate. See the section “Fraud Alarms Selectivity” for more details.
Programmable Parameters
The system operation is conditioned by the values given to certain parameters stored in the
permanent memory of the GC01 circuit board. When the control logic microprocessor executes the
resident program it consults the values of the programmable parameters and sets the timings of
certain actions and internal algorithms. The values of these parameters can be adjusted or reset
to a standard configuration by following the procedures given. The parameters together with their
locations and functional descriptions are listed in the annex “Parameter Table”.