Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 125 / 133

125
Appendix
Declar
ation
Spar
e P
ar
ts
Main
tenance
Insta
llation
Technica
l Inf
ormation
Instruc
tions f
or use
pr
oduc
t Description
In
tr
oduc
tion
Con
ten
ts
Oper
ation & Main
tenance Manual SpeedStile B
P DS
9. On the MB01 board select trimmer 1 and turn counter clockwise to position 1.
10. Press S1 to reset.
11. Set the MB01 board trimmers to required settings or follow default guide on page 120.
12. Press and hold for 2 seconds the S3 button on the MB01 board to launch the learning cycle,
a 0 should come on the MB01 LCD display followed by a L. The learning cycle will complete
automatically and normally takes about 4 minutes.
13. On the MB01 board select trimmer 1 and turn counter clockwise to position 0.
14. Press S1 to reset.
15. If the above has been applied to both MB01 boards the unit should now be in running
mode.
Firmware upload & Firmware coding
Control Board firmware code:
• FW0004AxxR: FW0004 is the code identifying the Control Board firmware;
the AxxR identifies the version.
Motor Board firmware code:
• FW0005AxxR: FW0005 is the code identifying the Motor Board firmware;
the AxxR identifies the version.
Upload procedure
The firmware on any boards of the gate is uploaded through the RS232 serial connection on the
GC01 board. The following procedure is a sub set of instructions sufficient to upload the firmware.
• In the laptop launch the OCConsole application;
• Click the Settings box.
Set the interface to 19200 br, the terminal to local echo, and the file transfer to “Wait for
handshake” with #42