Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 53 / 133

53
Appendix
Declar
ation
Spar
e P
ar
ts
Main
tenance
Insta
llation
Technica
l Inf
ormation
Instruc
tions f
or use
pr
oduc
t Description
In
tr
oduc
tion
Con
ten
ts
Oper
ation & Main
tenance Manual SpeedStile B
P DS
M6 ‘READER OPTO IN’
3
reader A authorisation
- wide
reader B authorisation
- wide
rated input voltage 24 VDC;
11 mA @ 24 VDC
4 GND GND
MB01 Addressable Outputs
M8 ‘READER OUT’
Pin
Master Side
Signal (*)
Slave Side
Signal (*)
NC/NO
Jumper
Relay LED
1, 2 Gate Busy A Gate Busy B W5 K4 DS15
3, 4 Ack A Reader Ack B Reader W4 K3 DS14
5, 6 Reader A Enable Reader B Enable W3 K1 DS12
7, 8 Ack Count A Ack Count B W2 K2 DS13
(*) operation depends on parameters configuration
Input Programming
The Inputs can be programmed to be linked to a Reader, whether A or B, or to be programmed as
the Fire Alarm inputs.
To program the inputs:
• Enter the menu Main-menu/Setup/IO;
• If the input to be programmed is on the GC01 board then select the Control Board
sub-menu.
• If the input to be programmed is on the MB01 master board then select the Master
Board sub-menu.
• If the input to be programmed is on the MB01 slave board then select the Slave
Board sub-menu.
Select the input to be programmed; any input can be programmed as:
1. READER –A: will be linked to the Reader A inter-face, trigger for a
normal passage.
2. WIDE READER –A: will be linked to the Reader A inter-face, trigger for an
Wide passage.
3. READER –B: will be linked to the Reader B inter-face, trigger for a
normal passage.
4. WIDE READER –B: will be linked to the Reader B inter-face, trigger for an
Wide passage.
5. FIRE ALARM: will be linked to the Fire Alarm functionality. See the
“Emergency” section below for more details