Gunnebo SpeedStile BP DS Standard Lane, Руководство по эксплуатации и техническому обслуживанию

Страница: 30 / 133

30
In
tr
oduc
tion
Pr
oduc
t Description
Instruc
tions f
or use
Technica
l Inf
ormation
Insta
llation
Main
tenance
Spar
e P
ar
ts
Appendix
Con
ten
ts
Declar
ation
Oper
ation & Main
tenance Manual SpeedStile B
P DS
Every time the gate is powered, the MB01 needs to make this zero setting before being able to
move normally.
The process will be done in Running Mode and not in Maintenance Mode as in the former.
The logic interrupts the zero setting cycle if:
• The emergency command is given.
• The gate is equipped with batteries and the main power fails.
• One or more of the four sensors close to the glass panels are engaged (see section
“Safety Photocells Management”).
n
ote
-t
he zero SettIng cycle reStartS once the oBStructIon IS cleared
.
In Running Mode- The zero settings will start to close reaching the close limit position and to
open reaching the open limit position.
If the zero settings have not been configured a ‘c’ will be displayed (see
section “MB01 Messages and LEDs”).
If the Zero settings cycle is running, both ‘f’ and ‘b’ will be the same time
displayed (see section “MB01 Messages and LEDs”).
In Maintenance Mode Several cycles take place after the first close/open,
because in Maintenance the absolute position
sensor switch also has to be learned.
n
ote
-I
f the zero SettIngS faIlS
,
the Board goeS In
f
ault condItIon
(
See SectIon
“S
how out of
S
ervIce
u
tIlIty
”)
and only a
h
ard reSet can clear thIS State
. I
n fault the engIne wIll Be unaBle to move any
more
.
Mechanism Speed
The gate panel speed is regulated with two trimmers on the MB01 board, TR2 trimmer for the
closing speed and TR3 for the opening speed. Each trimmer has six different settings.
The speed range covered by all the positions of the TR2 and TR3 trimmers allows, for each kind
of mechanism, the compliance with EN 12650 limits of the impact force.
n
ote
1-t
he mechanISm Speed IS the maIn factor for the lImItatIon of the Impact force In caSe of
collISIon wIth an oBject
.
n
ote
2- a
fter
tr2
or
tr3
trImmer poSItIon IS changed
,
the new poSItIon BecomeS effectIve only
after repeatIng the learnIng procedure
.