GE Voluson P8 BT16, Базовое руководство по обслуживанию

Страница: 82 / 612

GE RAFT V
OLUSON
™ P8 / V
OLUSON
™ P6
DIRECTION 5723243, R
EVISION
6 DRAFT (M
AY
23, 2018) B
ASIC
S
ERVICE
M
ANUAL
3-14 Section 3-5 - Connection of Auxiliary Devices
3-5-2 Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in: Section 3-6-3 on page 3-29 .
2.) Connect the Black & White printer according to correct connection scheme as described
in
Figure 3-6 on page 3-15
NOTE: The Black & White printer should be connected to the USB2 port of the Voluson™ P8 / Voluson™ P6´s
PC-part.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson™ P8 / Voluson™ P6 system as described in Section 3-6-2 on page
3-25 . All software drivers are pre-installed for the designated Black & White printer only.
5.) After physical connection to the Voluson™ P8 / Voluson™ P6 system, assign the printer to a remote
key (
P1
,
P2
, and
P3
) as described in Section 3-7-8 "Remote Control Selection" on page 3-52 .
6.) Verify the correct settings in the printer “Properties”, see: Section 3-7-7 "Adjustment of Printer
Settings" on page 3-48 .
WARNING WARNING
!! WARNING:
After each installation, the leakage currents have to be measured according to
IEC 60601-1 respectively UL 60601-1.