Gardsman CTC-1241GT, Руководство по установке

Страница: 60 / 73

56
4.16.1. Fault Message Display
z
When any fault situation persists, the
Control Panel will respond as below when
it is in Alarm off mode:
„ The Yellow LED will light to indicat
the fault condition.
Yellow LED on – Indicate fault situation in
the current Operating Area.
Yellow LED flash – Indicate fault situation
in the other Operating Area.
Yellow LED display:
Area1 Area 2 Fault situation
flash flash Faults exist in both
area 1 & 2 system.
light on flash Fault exists in area 1
flash light on Fault exists in area 2
off off No fault
„ The LCD will display the type and
source of the fault in the Fault
Display section of the User Menu.
„ A warning beep will emit every 30
seconds.
„ If a fault condition is detected while
the system is in full arm mode, the
fault event display will not be
generated until the system is
disarmed.
4.16.2. Clearing Fault Message
Display
z
The Yellow LED will turn off automatically
once all of faulty conditions are restored, or
any faulty devices are removed. It cannot
be cleared manually.
z
On the contrary, the fault message display
retains, even though the faulty conditions
have been restored.
z
The fault message can only be cleared
manually after the fault condition has been
rectified.
4.16.3. Viewing/Clearing the Fault
Message
To check what the fault condition is:
Step 1. When the system is in Alarm off mode.
Enter your PIN Code followed by OK .
Step 2. The screen will display:
F a u l t D s p
A r m
and the cursor stays at Fault Dsp
Step 3. Press OK to select Fault Dsp
Step 4. All the fault events are listed. Use
S & T key to move the cursor
downwards or upwards. The screen
is also scrolled down or up
respectively.
Step 5. After viewing all the fault events, press
key, a prompt message is displayed.
C l e a r F a u l t
D s p : ( O K ? )
Step 6. Press OK , then the fault event, which
the fault condition has been rectified,
will be cleared and the screen returns
to
Alarm off .
<
<
N
N
O
O
T
T
E
E
>
>
)
In Step 6 , if key is pressed, the
screen returns to Alarm off , the
Yellow LED stays on, the Control
Panel keeps emitting a short beep
every 30 seconds, and the fault event
display retains.
)
If the fault condition has not been
rectified, the fault event display will not
be cleared. It will come on again
while you try to arm the system and
the faulty condition inhibits the system
from being armed, then the fault
message will be displayed again. The
fault event display can be cleared only
after the fault condition has been
rectified.
)
Even when the fault messgae is
cleared, the fault event is still retained
in
Log .