FT-10 Fill Technical Manual, Rev. 2.21, July 2020
Page 57 of 131
Mode Related Display Messages
The messages below are shown on the display in the filling cycle or if there is any error in the filling.
Display
Operation
[-
Zero-
]
It is displayed during automatic zeroing before feeding.
[
GAtE
]
It is displayed during gate position control.
[
FuLL
] [ XXXXX ]
This prompt is displayed at the end of Filling by toggling with the
weight value. It disappears when emptying starts.
[
d_dEL
]
Emptying delay time in function.
[
E ZrnG
] [ XXXXX ]
This error means the weight is out of [
Zero_r
] at the beginning of
Filling cycle. Can be acknowledged by Start input.
[
E ZEro
] [ XXXXX ]
This message appears if zeroing cannot be done at the beginning
of filling because of the zeroing range (par. [
203
]) or unstable load.
It is shown alternately by the weight value.
Applying start input restarts the filling cycle. If this error seen
again, the second start input starts the feeding without zeroing.
[
E GAtE
]
Gate position error.
[
No FEEd
]
Feeding error message appears if weight value is not increased
after feeding output is activated. Refer to parameter [
508
].
[
FıLL t
]
This prompt announces that the filling is not finished in the filling
time and is ended. Error is cancelled by Reset input. Refer to
parameter [
509
].
Filling cycle
Press <
Zero
> key if the scale is not indicated zero after powered on. Apply start input to start feeding the
hopper. The two speed filling cycle is shown below. The [
FuLL
] prompt is displayed after end of the filling.
Emptying is start by “Start for Emptying” input. After emptying, press the start input again to go on filling.
Notes
1) There is a preact adjustment delay only in preact adjustment frequency ( refer to par. [503] ).
2) The fine feed output is activate together with coarse feed output if parameter [501] is 1 as indicated in the
