Chapter 4 Operation
44
Program Setup Mode
The program changes the target temperature (humidity) as dictated by a
program that you create in advance. Each program is a test pattern of
multiple steps. Each step contains a target temperature (humidity) and
exposure time. Only one program of a maximum 9 steps and a
maximum 99 repeated steps can be stored in memory at a time.
Program setup flow
The basic program setup flow is shown here below.
Get the program edit task selection.
Select “EDIT”
Input the test pattern.
Set up individual steps. (Max. 9 steps)
Make the setting.
Step
1
setup
Enter the setting.
Make the setting.
Step
2
setup
Enter the setting.
Input settings as needed for step 3 and after.
Make the setting.
Select “END” and press the
ENT.
key.
Step Settings and Selections
No., temperature (humidity) link control
ON/OFF, target temperature, humidity
control ON/OFF, target humidity, step
exposure time, soak control ON/OFF,
temperature ramp control ON/OFF, humidity
ramp control ON/OFF, step setup entry
Set the number of repeat cycles and end mode.
Set the number of repeat cycles. (0
99)
Number of repeat cycles
Repeat counter end step
Set the end mode. (HOLD/OFF/CNST)
End mode
Save the program.
End program editing.
Select the step edit content selection.
Select “SAVE” and press the
ENT.
key.
.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
