Chapter 4 Operation
36
4.2 Software Interface
The software installed in cabinets gives you finger-tip control over power
ON/OFF, operating mode selection, test starting/stopping, test setup and
monitoring. A function tree showing available modes and setup/monitor
items is given in Figs. 4.12 and 4.13. The sequence in which modes and
items are displayed can be checked in “Instrumentation Displays” in the
Appendix. The monitor mode is the default mode when control power is
activated from the POWER key. You can move to other modes by
pressing the SET key.
2. Target temperature (& humidity)
1.Test area temperature (& humidity)
1. Test area temperature (& humidity)
2. Target temperature (& humidity)
3. Time remaining to step end
4. Target step exposure time
5. Repeat cycles
6. Current step
While running under remote control
1. Test area temperature (& humidity)
2. Target temperature (& humidity)
3. Time remaining to step end
4. Target step exposure time
While on standby or in constant mode
While running in program mode
Monitor mode
Constant setup
mode
POWER key
SET key
1. Target temperature
2. Humidity control ON/OFF
3. Target humidity
SET key
SET key
Program setup
mode
To alarm setup mode
1. Program edit task selection EDIT/CLER
2. Step edit content selection STEP/END/SAVE
3. Step selection
4. Temperature (Humidity) link control status ON/OFF
5. Target temperature
6. Humidity control ON/OFF
7. Target humidity
8. Step exposure time
9. Soak control status ON/OFF
10. Temperature ramp control ON/OFF
11. Humidity ramp control ON/OFF
12. Step data enter command YES/NO
13. Number of repeat cycles
14. Repeat counter start step
15. Repeat counter end step
16. End mode HOLD/OFF/CNST
Fig. 4.12 Modes and functions 1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
