54
MP500/4N-8-16 Programming
4.18.2.3
Vocal message sending mode
Proceed as follows to configure vocal message sending mode:
1) Enter
<Master / Installer code>
, press
, then
and finally
repeatedly until TELEPHONE
DIALER appears.
2) Press
and then
.
3) Press
.
4) Press
.
5) Press
. Press
and
to select the sending mode. The sending mode applies to all vocal
messages. Press
to confirm.
6) Press
repeatedly to exit from the menu.
4.18.3
SMS text messages
The procedures for text messages are contained in the
User Manual
.
4.18.4
Alarm sending types
IMPORTANT!
Numeric codes with IDP protocol using an ATS4 external communicator is the only EN50131 grade 3 compliant
sending type. EN50131 grade 2 compliance may be obtained without ATS4.
All other sending types cancel EN50131 compliance.
However, the grade 2 alarm sending types which are added to the IDP sending mode (main mode) do not prevent or cancel
compliance.
The telephone dialler may interface with the outside world in various manners:
IDP
: the dialler sends alarms in form of numeric codes. This is only mode used for connecting to Alarm Receiving Centres.
for details on IDP message structure.
ADF
: same as IDP, with different protocol.
Modem
: the dialler exchanges information (sending and receiving) with a PC provided with Hi-Connect software.
SMS
: the dialler sends alarms in form of SMS text messages. These alarms can only be sent on the GSM network.
C200B
: same as IDP, with different protocol.
C200B P-P
: same as IDP, with different protocol.
Vocal
: the dialler sends alarms in form of vocal messages. See paragraph
IMPORTANT!
Respect the Alarm Receiving Centre requirements for sending using numeric codes (IDP, ADF, C200B, C200B
P-P).
One or more sending modes can be selected according to the alarm type to be sent.
The various possibilities are shown in the table in paragraph
Multiple, simultaneous alarms will be send in order of priority (0 = maximum priority, 8 = minimum priority - see table).
You can decide what alarm messages to send and the mode to be used for each telephone number. For example, burglar alarms can
be sent as a vocal message and Partition status
can be sent in a text message to a mobile phone.
Furthermore, the same message can be sent in multiple manner, e.g. by sending the burglar alarm to the same mobile phone as vocal
message and as text message. To do this, program the same telephone number in two different memory positions, one in vocal
sending mode and the other in text sending mode.
IMPORTANT!
The choice also depends on the associated channel (PSTN or GSM): the GSM network must be used for
sending text messages.
IMPORTANT!
Precise delivery times are not guaranteed for text messages and for this reason this mode should only be used
for alarms and messages which are not very important (low priority).
UT00:INSTALLER
TELEPHONE DIALER
TELEPHONE DIALER
VOCAL MESSAGES
VOCAL MESSAGES
MESSAGE LIST
VOCAL MESSAGES
VOCAL SEND.MODE
VOCAL SEND.MODE
MODE 1
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
