MP500/4N-8-16 Programming
83
5.7.2
Total disarming (system with areas and partitions)
Proceed as follows to disarm the entire alarm system if areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code>
.
2) Enter
or
on the keypad. The procedure will continue as for partitions only if you press
.
If you press
:
3) The keypad will beep. Press
to exit without disarming. The status LED will switch off after 5
seconds and the following will appear on the display
4) Press
again if you do not want to wait for 5 seconds.
5) The display will go back to standard view automatically after one minute. Press
to go to
standard view immediately.
IMPORTANT!
The user will disarm only the assigned areas and not necessarily all the areas
even with this procedure.
5.7.3
Partial disarming (system with partitions only)
Proceed as follows to disarm the alarm system partially if no areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code>
.
2) The keypad will beep. Press
to exit without disarming.
3) Enter the number of the partitions to be disarmed on the keypad: the respective squares will appear
empty.
IMPORTANT!
Simply enter the number directly if nine or fewer partitions have been programmed. If more than nine partitions
have been programmed, always enter two digits to select the partitions, including for numbers from 1 to 9 (1 = 01, 2 = 02 etc.).
4) The status LED will switch off after 5 seconds and the following will appear on the display
5) Press
if you do not want to wait for 5 seconds.
6) The display will go back to standard view automatically after one minute. Press
to go to
standard view immediately.
IMPORTANT!
The user will disarm only the assigned partitions and not necessarily all the partitions even with this procedure.
5.7.4
Partial disarming (system with areas and partitions)
Proceed as follows to disarm the alarm system partially if areas are defined:
1) Enter
<Master / User / Installer / Technical Manager code>
.
2) Enter
or
on the keypad. The procedure will continue as for partitions only if you press
.
If you press
:
3) The keypad will beep. Press
to exit without disarming.
4) Enter the number of the areas to be disarmed on the keypad: the respective squares will appear empty.
5) The status LED will switch off after 5 seconds and the following will appear on the display.
6) Press
if you do not want to wait for 5 seconds.
7) The display will go back to standard view automatically after one minute. Press
to go to
standard view immediately.
IMPORTANT!
The user will disarm only the assigned areas and not necessarily all the areas even with this procedure.
1)AREAS
2)PARTITIONS
DISARM
■■□□
EXECUTED
□□□□
DISARM
■□□■••••••••••••
EXECUTED
□□□■••••••••••••
1)AREAS
2)PARTITIONS
DISARM
■■••
EXECUTED
■□••
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
