MP500/4N-8-16 Programming
89
5.9.6
Partial disarming from KP500DP/N keypad
Proceed as follows to disarm some partitions using the proximity key on a KP500DP/N keypad:
1) Approach the proximity key to the keypad.
2) The keypad will beep. Press
to exit without disarming.
3) Enter the number of the partitions to be disarmed on the keypad.
4) After 5 seconds, the status LED will switch off and the squares will become empty indicating that the
partitions have been disarmed. The following will appear on the display:
5) The display will go back to standard view automatically after one minute. Press
to go to
standard view immediately.
IMPORTANT!
The key will disarm only the assigned partitions and not necessarily all the partitions
even with this procedure.
IMPORTANT!
The LED
H
/ST keypad) will light up and the
buzzer will sound to indicate an error (long beep) if a key which can be not been acquired (the key
is not recognised) or which has not been enabled is used.
5.10 DISARMING USING RC500 REMOTE CONTROL
5.10.1
Total system disarming
The remote control must have been duly programmed to disarm all the partitions in the system (see Programming Manual).
Press
to disarm the entire system using the remote control. The remote control buzzer will beep if the control panel acknowledges
the command.
5.10.2
Partial disarming with remote control
The remote control must have been duly programmed to partially disarm some the partitions in the system (see Programming Manual).
Press
on the remote control to disarm the partitions to which the remote control is assigned. The remote control buzzer will beep if
the control panel acknowledges the command.
IMPORTANT!
Simply enter the number directly if nine or fewer partitions have been programmed.
If more than nine partitions have been programmed, always enter two digits to select the partitions,
including for numbers from 1 to 9 (1 = 01, 2 = 02 etc.).
DISARM
PARTITIONS
EXECUTED
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
