MP500/4N-8-16 Programming
119
9.4.3
Preliminary operations
Check the firmware version of the devices to be upgraded.
Download the files related to the devices to be upgraded from the installer area on the Elkron website (www.elkron.com).
Save the downloaded files on a USB memory stick in the subfolders created as shown in paragraph
ADVICE:
Before upgrading the devices connected to the bus, it is advisable to save programming and configuration data of
the entire system (.cfg) and the code and key file (.cod). The procedure is shown in paragraph
IMPORTANT!
The “*.bin” files are supplied by Elkron only. Do not edit or open the files for any reason: they are encrypted in a
proprietary binary format and protected by check fields and CRC to preserve content.
Do not download binary files from website other than the Elkron official website (www.elkron.com).
9.4.4
How to upgrade bus devices
Proceed as follows to upgrade the firmware of bus devices:
1) Plug the IT USB/KEY interface into the J11 connector of the control panel.
2) Insert the USB memory stick (e.g. USB flash drive) with upgrade files in the IT USB/KEY interface.
3) Enter
<Installer code>
, press
, then
and finally
repeatedly until MAINTENANCE
appears.
4) Press
and then
several times until FIRMWARE UPDATE appears.
5) Press
. Press
and
to select whether to upgrade the entire system (ALL THE DEVICES)
or upgrade only a specific device type (expansions, keypads, readers). Press
to confirm.
6) Press
again when the confirmation prompt appears.
IMPORTANT!
The devices which have already been upgraded to the firmware release of
the files on the USB memory stick will not be concerned by the upgrade procedure.
The advancement will appear on the keypad display and on the run LED of the control panel after starting the upgrade procedure. The
result will appear at the end of the procedure.
IMPORTANT!
The advancement state will only appear if the keypad is not being upgraded. In this case, the keypad will not
show any until upgrading is finished).
The upgrade procedure may take several minutes, indicatively approximately 4 minutes for the keypad only, less for other devices
individually. It will take longer if several device types are upgraded at the same time. The control panel will light up the run LED
according to the “Running” sequence (blinking for 1.6 seconds - off for 0.5 seconds).
IMPORTANT!
Do not remove the flash drive until the upgrade procedure is completed.
Upgrade results are:
Positive result
. The procedure was successful. The run LED will light up on the control panel according to the “Successful
Update” sequence (off for 2 seconds - blinking for 2 seconds).
Negative result
. The pro
cedure was interrupted or is not OK. The run LED will light up on the control panel according to the “Update
was not successful” sequence (on for 2 seconds - blinking for 2 seconds). The message “END DOWNLOAD KO” will appear on the
keypad.
Details on the firmware upgrading procedure will be saved in the Event Log in both cases at the end of the operation.
UT00:INSTALLER
MAINTENANCE
MAINTENANCE
FIRMWARE UPDATE
FIRMWARE UPDATE
ALL THE DEVICES
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
