MP500/4N-8-16 Programming
81
5.4.6
Partial arming from KP500DP/N keypad
Proceed as follows to arm the partitions partially using the proximity key on a KP500DP/N keypad:
1) Approach the proximity key to the keypad transponder.
2) The keypad will beep. Press
F4
within 5 seconds. Press
to exit without arming.
3) Enter the number of the partitions to be armed on the keypad: the respective squares will become full.
4) The status LED will light up after 5 seconds. The following will appear on the display:
IMPORTANT!
The user will arm only the assigned partitions and not necessarily all the partitions
even with this procedure.
5) The display will go back to standard view automatically after one minute. Press
to go to standard
view immediately.
IMPORTANT!
The key will arm only the assigned partitions and not necessarily all the partitions
even with this procedure.
IMPORTANT!
The LED
H
Figure 3 - KP500DP/N - KP500D/ST keypad
)) will light up and the
buzzer will sound to indicate an error (long beep) if a key which can be not been acquired (the key
is not recognised) or which has not been enabled is used.
5.5
ARMING USING RC500 REMOTE CONTROL
5.5.1
Total arming
The remote control must have been duly programmed for all partitions to arm all the partitions in the system.
Press the
on the remote control to arm all partitions. The remote control buzzer will beep if the control panel acknowledges the
command.
Note:
The system can be armed/disarmed also by using the
(toggle) key. Importantly, this key works as follows:
1. Pressing the key will cause the system status to switch from disarmed to armed and vice versa (toggle).
2. If the system is partially armed (partial arming), pressing the key will cause the system to be armed completely: any partitions
which are disarmed will be armed.
3. Pressing the key again will cause the system to be totally disarmed (the entire system, not only the armed partitions).
IMPORTANT!
Simply enter the number directly if nine or fewer partitions have been programmed.
If more than nine partitions have been programmed, always enter two digits to select the
partitions, including for numbers from 1 to 9 (1 = 01, 2 = 02 etc.).
EXECUTED
PARTITIONS
ARM
ARM
Содержание MP500/16
Страница 139: ...MP500 4N 8 16 Programming 139 ...
